98 honda accord starter installation

The factory sound system has a coded theft protection system. It is recommended that you know your reset code before you begin.

When installing the heavy gauge starter cable, make sure the crimped side of the terminal end is facing out. Location of the starter mounting bolts and wiring. Unfasten the two bolts that mount the starter to the transaxle assembly, then remove the starter. Auto Repair Questions. Login or register to post comments. Before commencing with the starting system diagnostics, verify:. The ignition system must be disabled to prevent engine start while performing the following tests.

Do not overheat the starter motor or draw the battery voltage below 9. Observe the voltmeter. If the voltage is detected, correct the poor contact between the cable clamp and post. Before testing, assure the parking brake is set, the transaxle is in Park automatic or Neutral manual , and the battery is fully charged and in good condition. Note the radio security code and the radio presets.

Disconnect the negative battery cable. Install the starter in the reverse order of removal. Tighten the starter mounting bolts to 33 ft. Enter the anti-theft code and radio presets. Disconnect the negative, then the positive battery cable. Starters are on the side of the motor facing the transmission. Yours maybe closer to the firewall to your car if its front wheel drive and easier to get to from underneath the car Was this answer.

My ac doesnt work. I do not see any leaking from my hoses. What could it be? What kind of water? Not coolant? AC dont work when did it stop working? I assume its from my coolant for the motor cause im over heating, the ac hasnt worked since I bought it cause I cant get freon.

The car is overheating and the water runs out too fast to get anywhere really. That big a leak should be detectable? Have you tried to locate? Starter is on left side front or rear of trans? Could be soft plug or hard metal line? I dont know what those are? Could you elaborate? What is as soft plug? Now contributing to various online publications, he specializes in auto repair, home maintenance and similar topics.

Rose studied English at Frostburg State University. Step 1 Open the engine compartment and disconnect the negative battery terminal by loosening the nut with a wrench.

Step 2 Raise the car up on the driver's side and place a jack stand under the frame. Step 3 Remove the lower radiator hose from the bracket on the starter by pulling it off. Step 4 Remove the two mounting bolts from the starter using a ratchet and socket. Step 5 Put the new starter in place and tighten the bolts with the socket and ratchet.

Step 6 Remove the jack stand from under the car and lower the car back to the ground. Tips The factory stereo in the Honda Accord has a theft protection system built in that is coded.

Make sure you know the code before disconnecting the battery so you'll be able to reactivate the stereo system.